Maxim-integrated 78M6610+LMU Evaluation Kit Bedienungsanleitung PDF herunterladen (Seite 10)

78M6610+LMU Evaluation Kit User Manual

10 Rev 1

3.2.1 Jumper Position Changes

Move J23 and J24 jumpers to position CT to use CT2 for sensor slot S1.

J23 Jumper Description

J23 Pins

Description

Jumper

1/2 Connect J15 SHUNT to 78M6610+LMU Sensor Slot 1 -

2/3 Connect J10 CT2+ to 78M6610+LMU Sensor Slot 1 Installed

J24 Jumper Description

J24 Pins Description Jumper

1/2 Connects J8 SHUNT to 78M6610+LMU Sensor Slot 1 -

2/3 Connects J10 CT2- to 78M6610+LMU Sensor Slot 1 Installed

J9 Jumper Description

J9 Pins

Description

Jumper

1/2 Connect AC Neutral to V3P3A (chip reference) Installed

3.2.2 Device Configuration

Use the Configuration tab to map the sensors as shown in the table below. Re-enter the gain value as needed

for CT2 into the S1_GAIN register.

Voltage

Current

-S2

Pre-Amp

1X S1

1X S3

Note: The values for VC will not be displayed correctly on the Power tab of the provided GUI due to the

increased full-scale value of VC. Reported results for measurements derived from VC will be one-half the

expected magnitude.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Keine Kommentare

Maxim-integrated 78M6610+LMU Evaluation Kit Bedienungsanleitung Seite 10