Maxim-integrated MAXQ622 Bedienungsanleitung PDF herunterladen (Seite 158)

MAXQ612/MAXQ622 User’s Guide

Maxim Integrated 11-3

flag is set (I2CTXI = 1). The I2CTXI flag is set after the acknowledge bit has been received from the slave. This gener-

ates an interrupt to the CPU if the transmit interrupt is enabled (I2CTXIE = 1). On receiving acknowledgement (ACK)

from the slave, the master can then start transmitting data bytes to the slave. The master refrains from generating the

SCL clock until data has been written to I2CBUF. The I

C controller starts generating the SCL clock only after the

I2CBUF has been written to and the necessary SCL low time requirement has been satisfied. There is no limit as to the

number of bytes to be transmitted. The master concludes the transfer by generating the STOP condition (I2CSTOP = 1)

and releasing the I

C signals.

Figure 11-2. I

C Master-Transmitter Data Transfer

Figure 11-3. I

C Master-Transmitter and Master-Receiver

S DATA0SLAVE ADDR A PA DATA A

WRITE

MASTER TO SLAVE

SLAVE TO MASTER

DATA TRANSFERRED

(n BYTES + ACKNOWLEDGE)

BEGIN

END

(A) MASTER TRANSMITTER

GENERATE

START

TRANSMIT

DATA

ANY MORE?

GENERATE

STOP

TRANSMIT

SLAVE

ADDRESS

BEGIN

END

(B) MASTER RECEIVER

GENERATE

START

RECEIVE

DATA

ANY MORE?

GENERATE

STOP

TRANSMIT

SLAVE

ADDRESS

1 2 ... 153 154 155 156 157 158 159 160 161 162 163 ... 254 255

Kommentare zu diesen Handbüchern

Keine Kommentare

Maxim-integrated MAXQ622 Bedienungsanleitung Seite 158

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Maxim-integrated MAXQ622